Trane TruSense RMWH - Alarms; Faults; Calibration

Routine Operation
34 RMWH-SVX001C-EN
In the Event Log, events are color coded by type:
• Red = Caution, Warning, Alarm
• Yellow = Fault, Unsuccessful Cali
bration
•
Green = Successful Calibration
Select any event on the All tab to see a pop-up with the
event details.
Alarms
The Alarms tab shows a list of alarm events for the device.
Non-latching alarm events that resolved without being
acknow
ledged are indicated by a number in parentheses
after the Alarms tab heading.
A single alarm event is divided into two events in the event
log: one for the initiation of the alarm and another for the
conclusion of the alarm.
The last 100 events show in chronological order. When
there are 100 events in the list and a new event occurs, the
oldest event is
deleted to make space for the new event to
show.
Use the scroll bar to move through the list of events.
Select any
event on the Alarms tab
to see a pop-up with
event details.
Faults
The Faults tab shows a list of all fault events for the device.
The last 100 events show in chronological order. When
there are 100 events in the list and a new event occurs, the
oldest event is
deleted to make space for the new event to
show.
Use the scroll bar to move through the
list of events.
Select any event on
the Faults tab to see a pop-up with
e
vent details. The detailed view shows the board location,
if applicable, and the software error code.
Calibration
The Calibration tab shows a list of calibration attempts
for the device.