© Copyright 2018 TRENDnet. All Rights Reserved.
Initial Setup
Access the management page
Note: Your access point management page URL/domain name http://TEW-826dap or IP
address (default: http://192.168.10.100) is accessed through the use of your Internet
web browser (e.g. Internet Explorer, Firefox, Chrome, Safari, Opera) and will be
referenced frequently in this User’s Guide.
If there is no DHCP server on your network and you are configuring a factory
default unit you MUST statically configure the IP address and subnet mask of
your computer to the following:
IP Address: 192.168.10.xxx (except 192.168.10.100)
Subnet Mask: 255.255.255.0
1. Open your web browser (e.g. Internet Explorer, Firefox, Safari, Chrome, or Opera)
and go to URL/domain name http://TEW-826dap or IP address
http://192.168.10.100. Your access point will prompt you for a user name and
password.
2. You can find your device's default SSID and WiFi password on the white labels
located on the device. Use this information to connect to the TEW-826DAP access
point.
3. Enter your Username and Password, select your preferred language, and then click
Login.
Setup Wizard
If it is the first-time you are logging into the device, you will automatically be
prompted to run through the setup wizard.
1. For your security, the first step is to change the login password of the access
point. Enter your new login password and click OK.
To Next Page
Loading...
Need help?
General
