TRENDnet TEW-826DAP User Manual

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
52
LED Control
Management > LED Control
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the Management tab and click LED Control.
3. Review the settings and click Save to save settings.
 Power LED: Select ON to leave Power LED on or OFF option to turn off.
 LAN LED: Select ON to leave LAN LED on or OFF option to turn off.
 2.4GHz LED: Select ON to leave wireless 2.4GHz LED on or OFF option to
turn off.
 5GHz1 LED: Select ON to leave wireless 5GHz1 LED on or OFF option to
turn off.
 5GHz2 LED: Select ON to leave wireless 5GHz2 LED on or OFF option to
turn off.
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.

TRENDnet TEW-826DAP Specifications

General

Brand	TRENDnet
Model	TEW-826DAP
Category	Wireless Access Point
Language	English