© Copyright 2018 TRENDnet. All Rights Reserved.
5. Configure the below settings and click Save to save settings.
Wireless Mode: Select the wireless mode to set on the selected wireless
band in client bridge mode
SSID: Manually enter the wireless network name (SSID) you want to
establish connection. Or simply click on Site Survey to scan for available
wireless network (more on this function in below section).
Preferred BSSID: Click option and enter the MAC address of the preferred
wireless network you would like to connect to.
Repeater SSID: You may specify a new SSID name to use
Security Mode: Select from the pull-down menu the wireless security that
is used on the wireless network you would like to connect to.
6. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
Repeater: Scan for wireless networks
Wireless (2.4GHz, 5GHz1, or 5GHz2) > Wireless Network
This section outlines the available features to configure for both wireless 2.4 GHz and
5GHz when Repeater mode is selected.
1. Log into your management page (see “Access the management page” on page
16).
2. Click on the wireless band you would like to configure and click Wireless
Network.
3. Under SSID section click Site Survey to wireless scan for available wireless
networks.
To Next Page
Loading...
Need help?
General
