TRENDnet TEW-826DAP - Management; Administration; Administrator Settings; Device Name Settings

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-826DAP
43
Management
Administration
Management > Administration
Administrator Settings:
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the Management tab and click Administration.
3. Review the settings and click Save to save settings.
 Account: Change the login user name in this field
 Password: Change the login password in this field
 Idle Timeout: Change the length of time that the access point can idle
before timing out. The duration can be between 120 – 3600 seconds. (By
default it is set to 120 seconds)
Device Name Settings:
Management > Administration
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the Management tab and click Administration.
3. Review the settings and click Save to save settings.
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.