© Copyright 2018 TRENDnet. All Rights Reserved.
Schedules
Management > Schedule
Create a schedule to define the days/time period when a feature should be active or
inactive:
1. Log into your management page (see “Access the management page” on page
8).
2. Click on the Management tab and click Schedule.
3. Select from the pull-down menu under Add Schedule Rule to Enable wireless
schedules.
4. Review the settings and click Add to save settings.
Rule Name: Enter desired schedule name.
Service: Allows you to set one of the actions either to Reboot the device,
activate 2.4GHz or 5GHz or both bands.
Day: Check the day(s) to implement the schedule.
Start Time: Specify the time when this schedule will be in effect.
End Time: Specify the time when this schedule will end.
5. After you are done Adding the schedule, Click on the Save button in the ABOVE
SECTION then click on the flashing Apply/Discard button located on the top left
section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
To Next Page
Loading...
Need help?
General
