© Copyright 2018 TRENDnet. All Rights Reserved.
N/AC mixed: Select this mode for the best compatibility. This mode allows
older 802.11a wireless devices to connect to the access point in addition to
newer 802.11ac devices.
AC only: This mode only allows devices to connect to the access point
using newer and faster 802.11ac technology (typically not recommended).
A/N/AC mixed: Select this mode for the best compatibility. This mode
allows older 802.11a and 802.11n wireless devices to connect to the access
point in addition to newer 802.11ac devices.
Note: Please check the specifications on your wireless devices for the highest wireless
capability supported first before applying these settings. If you are unsure, it is
recommended that you keep the default setting (A/N/AC mixed) for the best
compatibility.
When applying the 802.11 mode setting, please keep in mind the following:
Wireless devices that support 802.11n are backwards compatible and can
connect wirelessly at 802.11g or 802.11b.
Connecting at 802.11b or 802.11g will limit the capability of your 802.11n
supported wireless devices from obtaining higher performance and data
rates.
Allowing 802.11b or 802.11g devices to connect to an 802.11n capable
wireless network may degrade the wireless network performance below
the higher performance and data rates of 802.11n.
Wireless devices that only support 802.11b or 802.11g will not be able to
connect to a wireless network that is set to 802.11n only mode.
Wireless devices that only support 802.11b will not be able to connect to a
wireless network that is set to 802.11g only mode.
Channel Width: Select the channel width for the access point to operate
on. By default, the access point is on Auto 20/40 MHz.
Extension channel: When 20/40 channel bandwidth has been chosen, you
should select extension channel to get higher throughput.
Frequency (Channel): In North America, this access point can broadcast on
1 of 11 Channels for 2.4GHz (13 in Europe and other countries). Selecting
the Auto option enables the access point to automatically select the best
Channel for wireless communication. To manually set the channel on which
the access point will broadcast, click the drop-down list and select the
desired Channel for wireless communication. The goal is to select the
Channel that is least used by neighboring wireless networks.
4. Click on the Save button then click on the flashing Apply/Discard button
located on the top left section, and click Save & Apply to apply the settings.
Note: Your configurations are not saved and applied until you click on Apply/Discard
Changes button. The Save & Apply step saves and applies all configuration changes.
To Next Page
Loading...
Need help?
General
