16 Software Utilities
156 5700/5800 GPS Receiver User Guide
5800 Operation
WinFlash guides you through the firmware upgrade process. The steps
required are described below. For more information, refer to the
WinFlash Help.
To upgrade the 5800 receiver firmware:
1. Start WinFlash.
The Device Configuration screen appears.
2. From the Device type list select 5800 Receiver.
3. From the PC serial port field select the serial (COM) port on
the computer that the receiver is connected to.
4. Click
Next.
The Operation Selection screen appears. The Operations list
shows all of the supported operations for the selected device. A
description of the selected operation is shown in the Description
field.
5. Select GPS software upgrade and click
Next.
The GPS Software Selection window appears. This screen
prompts you to select the software that you want to install on
the 5800 receiver.
6. Select the latest version from the Available Software list and
click
Next.
The Settings Review window appears. This screen prompts you
to connect the receiver, suggests a connection method, and then
lists the receiver configuration and selected operation.
7. If all is correct, click
Finish.
Based on the selections shown above, the Software Upgrade
window appears and shows the status of the operation (for
example,
Establishing communication with the 5800. Please wait…
).
8. Click
OK.
The Software Upgrade window appears again and states that the
operation was completed successfully.
To Next Page
Loading...