Trimble 5700 - Adding frequencies for the 450 MHz internal radio

5700/5800 GPS Receiver User Guide 157
Software Utilities 16
5800 Operation
9. Click Menu to select another operation, or click Exit to quit
WinFlash.
10. If you click
Exit, another screen appears asking you to confirm
that you want to quit WinFlash. Click
OK.
160.1 Adding frequencies for the 450 MHz internal radio
If your 5800 receiver has the optional internal 450 MHz radio
installed, you must use WinFlash to add frequencies to the default list.
To add radio frequencies:
1. Start WinFlash.
The Device Configuration screen appears.
2. From the Device type list select 5800 Receiver.
3. From the PC serial port field select the serial (COM) port on
the computer that the receiver is connected to.
4. Click
Next.
The Operation Selection screen appears. The Operations list
shows all of the supported operations for the selected device. A
description of the selected operation is shown in the Description
field.