Trimble 5700 - Adding frequencies for the 450 MHz internal radio

5700/5800 GPS Receiver User Guide 85
Software Utilities 7
5700 Operation
10. If you click Exit, another screen appears asking you to confirm
that you want to quit WinFlash. Click
OK.
70.1 Adding frequencies for the 450 MHz internal radio
If your 5700 receiver has the optional internal radio installed, you can
use WinFlash to add frequencies to the default list.
To add radio frequencies:
1. Start WinFlash.
The Device Configuration screen appears.
2. From the Device type list select 5700 Receiver.
3. From the PC serial port field select the serial (COM) port on
the computer that the receiver is connected to.
4. Click
Next.
The Operation Selection screen appears. The Operations list
shows all of the supported operations for the selected device. A
description of the selected operation is shown in the Description
field.
5. Select Configure Radio and click
Next.