Trimble 5700 - Configuring the internal 900 MHz radio setup

5700/5800 GPS Receiver User Guide 159
Software Utilities 16
5800 Operation
8. Press Add. The new frequency appears in the Selected
Frequencies list.
Note – The frequencies that you program must conform to the
channel spacing and minimum tuning requirements for the
radio. To view this information, click
Radio Info. You may
select either 12.5 or 25 kHz channel spacing. All radios in your
network must use the same channel spacing.
9. When you have configured all the frequencies you require, click
OK.
WinFlash updates the 5800 receiver’s radio frequencies and
then restarts the receiver.
160.1 Configuring the internal 900 MHz radio setup
To configure the internal 900 MHz radio, use one of the following:
• Trimble Survey Controller running on a Trimble controller
• WinFlash (provided on the Trimble R7, Trimble R8, 5700, and
5800 GPS Receivers CD)
The internal radio has 40 available networks. You must choose the
same network that is configured in the base radio you want to receive
from.
Trimble Survey Controller
To configure your radio network using Trimble Survey Controller:
1. Connect to the 5800 receiver with Bluetooth (or the appropriate
data cable if necessary).
2. From the main menu on the controller, select Configuration.
3. In the dialog that appears, select Survey styles, then from the
Type field, select RTK.
4. Select Rover radio, then from the Type field select Trimble
Internal.