16 Software Utilities
160 5700/5800 GPS Receiver User Guide
5800 Operation
5. Tap the Connect softkey.
6. Once connected, in the Network number field enter the number
of the network set on your base radio.
Note – The Base Radio Mode field is not used here.
7. Tap the Enter softkey to complete configuration.
WinFlash
To configure the radio network using WinFlash:
1. Connect the data/power cable to Port 1 on the receiver.
2. Connect the female DE-9 connector on the other end of the
data/power cable to a serial (COM) port on the computer.
3. Start WinFlash. The Device Configuration dialog appears.
4. From the Device type list, select 5800 Receiver.
5. From the PC serial port field, select the serial port on the
computer that the receiver is connected to and click
Next.
6. From the Operation selection dialog, select Configure radio and
click
Next.
7. Confirm that your current settings are correct and click
Finish.
The Configure 900MHz radio dialog appears.
8. In the Network number field, select the same network that is set
on your base radio.
9. In the Country setting field, select one of the following
(according to how your base radio was shipped):
– Your country (if available). This sets the radio to the a
specific frequency range being transmitted by the base
radio.
– A single frequency. This limits the frequencies used to
those authorized in your particular country.
10. Click OK.
WinFlash updates the radio settings and then restarts the receiver.
To Next Page
Loading...