Trimble 5700 - Resetting to Factory Defaults

9 Default Settings
96 5700/5800 GPS Receiver User Guide
5700 Operation
9.3 Resetting to Factory Defaults
You can reset your 5700 receiver to its factory defaults, as defined
above, in either of the following ways:
• Press and hold down p on the 5700 receiver for 15 seconds.
• In Configuration Toolbox, select Communication / Reset
receiver and click
Reset.
Reference position: Latitude 0°
Longitude 0°
Altitude 0.00 m HAE
Antenna: Type Unknown external
Height (true vertical) 0.00 m
Group All
Measurement method Bottom of antenna mount
Logging rate 15 sec
Position rate 5 min
Measurement rate 10 Hz
Table 9.1 Default settings (continued)
Function Factory Default