6 Getting started GeoExplorer Series Getting Started Guide
Getting started
Follow the steps below to get started with the GeoExplorer series
handheld. For information on using the handheld, see Pocket PC basics,
page 8.
1 Charge the battery
Before using the handheld for the first time, you must charge the battery.
Connect one end of the AC adaptor cable to the support module and the
other to an AC power outlet, and put the handheld in the support module
as shown above. The handheld turns on. Leave to charge for up to five
hours. Press F2 to view Power Settings and check the level of charge in the
battery.
To remove the handheld from the support module, press the release
button on the support module, then lift the bottom of the handheld
upward.
2 Turn on and suspend
Press and release the Power button to turn on or to
suspend the handheld.
For more information, see Suspend mode, page 20.
To Next Page
Loading...