110
Maintenance and Adjustment
Note:
• The motorcycle is delivered from
the factory with the rear
suspension set at the standard
settings, as shown in the relevant
suspension chart (see page 10 9 ).
• These charts are only a guide.
Setting requirements may vary for
rider weight and personal
preferences. See the following
pages for information regarding
suspension adjustment.
Rear Suspension Adjustment
The rear suspension unit on this motorcycle is
adjustable for spring pre-load and rebound
damping.
Spring Pre-Load Adjustment
1. Spring pre-load adjuster
The spring pre-load adjuster is situated on
the right hand side of the motorcycle, at the
top of the rear suspension unit.
To adjust the spring pre-load setting rotate
the adjuster clockwise to increase, or counter-
clockwise to decrease.
Note:
• The setting is measured as the
number of adjuster 'clicks'
counter-clockwise from the fully
clockwise (hardest) position.
• The motorcycle is delivered from
the factory with the spring
pre-load set 20 clicks
counter-clockwise from the fully
clockwise position.
Ensure that the correct balance between
front and rear suspension is maintained.
Suspension imbalance could significantly
change handling characteristics leading to
loss of control and an accident. Refer to the
front and rear suspension setting charts for
further information or consult your dealer.
To Next Page
Loading...
