Triumph Tiger Explorer User Manual

54
General Information
To activate cruise control, the following
conditions have to be met:
• The motorcycle is travelling at a
speed between 30 to 100 mph
(48 - 160 km/h);
• The motorcycle is in 4th gear or
higher;
• The SET/- on the adjust button is
pressed.
The cruise control lamp will illuminate
indicating that cruise control is active and set.
1. Cruise control lamp
Resuming the Cruise Control Set
Speed
Cruise control will be deactivated if one of the
following actions has been taken:
• Roll the throttle twist grip fully
forward;
• Press and release the on/off button
on the right hand switch cube;
• Pull the clutch lever;
• Operate the front or rear brake;
• Increase speed by using the throttle
grip for more than 60 seconds.
MIN
-1
x 1000
TC
1
Warning
When resuming cruise control, always
ensure that the traffic conditions are
suitable for the set speed.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when they
are slippery, may result in loss of
motorcycle control and an accident.

Triumph Tiger Explorer Specifications

General

Displacement	1215 cc
Transmission	6-speed
Final Drive	Shaft
Tires Front	110/80 R19
Tires Rear	150/70 R17
Engine Type	Liquid-cooled, 12-valve, DOHC, inline 3-cylinder
Fuel System	fuel injection
Front Suspension	adjustable rebound and compression damping
Rear Suspension	adjustable rebound damping
Front Brakes	Dual 305mm floating discs, 4-piston calipers, ABS
Rear Brakes	Single 282mm disc, ABS
Frame	Tubular steel trellis frame
Fuel Capacity	20 L (5.2 US gal)