111
Maintenance and Adjustment
Rebound Damping Adjustment
1. Rebound damping adjuster
The rebound damping adjuster is located at
the bottom of the rear suspension unit and is
accessible from left hand side of the
motorcycle.
To adjust the rebound damping setting,
rotate the slotted adjuster clockwise to
increase, and counter-clockwise to decrease.
Note:
• The setting is measured as the
number of adjuster clicks
counter-clockwise from the fully
clockwise (hardest) position.
• The motorcycle is delivered from
the factory with the rebound
adjuster set to 12 clicks
counter-clockwise from the fully
clockwise position.
Tires
This model is equipped with tubeless tires,
valves and wheel rims. Use only tires marked
'TUBELESS' and tubeless valves on rims
marked 'SUITABLE FOR TUBELESS TIRES'.
1
chgq
Do not install tube-type tires on tubeless
rims. The bead will not seat and the tires
could slip on the rims, causing rapid tire
deflation that may result in a loss of vehicle
control and an accident. Never install an
inner tube inside a tubeless tire. This will
cause friction inside the tire and the
resulting heat build-up may cause the tube
to burst resulting in rapid tire deflation, loss
of vehicle control and an accident.
To Next Page
Loading...
