49
General Information
Headlight Dimmer Switch
High or low beam can be selected with the
headlight dimmer switch. To select high
beam, push the switch forward. To select low
beam, push the switch rearwards. When the
high beam is turned on, the high beam
indicator light will illuminate.
Note:
• A lighting on/off switch is not
fitted to this model. The position
light, brake/tail light and license
plate light all function
automatically when the ignition is
turned to the ON position.
• The headlight will only function
when the ignition switch is turned
to the ON position and the engine
is running.
An alternate way to turn on the
headlight, without the engine
running, is to pull in the clutch
lever then turn the ignition to the
ON position. The headlight will be
on and remain on when the clutch
lever is released.
The headlight will go off while
pressing the starter button until
the engine starts.
Turn Signal Switch
When the turn signal switch is pushed to the
left or right and released, the corresponding
turn signals will flash on and off.
The turn signal self cancel system becomes
active eight seconds after operating a turn
signal. Eight seconds after turning the turn
signal on and after riding a further 65 meters,
the turn signal self cancel system will
automatically turn off the turn signal. The
turn signals can be cancelled manually. To
manually turn off the turn signals, press and
release the turn signal switch in the central
position.
To disable the turn signal self cancel system
see page 29. To manually turn off the turn
signals, press and release the turn signal
switch in the central position.
To Next Page
Loading...
