67
General Information
To adjust the windshield, loosen left and right
hand adjuster knobs sufficiently to allow the
adjustment blocks to slide over the
adjustment plates.
Position the windshield to the desired height,
ensuring both adjustment plates are set to
the same position.
Tighten the adjuster knobs to secure the
windshield in position.
See page 12 8 for windshield cleaning
information.
Breaking-In
Breaking-in is the name given to the process
that occurs during the first hours of a new
vehicle's operation.
In particular, internal friction in the engine will
be higher when components are new. Later
on, when continued operation of the engine
has ensured that the components have
'bedded in', this internal friction will be
greatly reduced.
A period of careful breaking-in will ensure
lower exhaust emissions, and will optimize
performance, fuel economy and longevity of
the engine and other motorcycle
components.
During the first 500 miles (800 kilometers):
• Do not use full throttle.
• Avoid high engine speeds at all
times.
• Avoid riding at one constant engine
speed, whether fast or slow, for a
long period of time.
• Avoid aggressive starts, stops, and
rapid accelerations, except in an
emergency.
• Do not ride at speeds greater than
3/4 of maximum engine speed.
Always ensure that the windshield
adjusters are adjusted to the same position.
Riding the motorcycle with an incorrectly
adjusted windshield could cause loss of
motorcycle control and an accident.
Always ensure both windshield adjusters
are tightened before riding the motorcycle.
Riding the motorcycle with a loose
windshield or windshield adjuster could
cause loss of motorcycle control and an
accident.
To Next Page
Loading...
