122
Maintenance and Adjustment
Headlight Adjustment
Each headlight can be adjusted by means of
vertical and horizontal adjustment screws
located on the rear of each headlight. In
addition, the headlight is equipped with an
easily accessible adjuster to allow the vertical
adjustment to be corrected when the
motorcycle is fully loaded.
1. Horizontal adjustment screw
2. Vertical adjustment screw
3. Headlight adjuster lever for loaded
conditions
Switch the headlight dipped beam on.
Turn the vertical adjustment screw on the
headlight clockwise to raise the beam or
counter-clockwise to lower the beam.
Turn the horizontal adjustment screw
clockwise to move the beam to the right or
counter-clockwise to move the beam to the
left.
Switch the headlights off when the beam
settings are satisfactory.
Headlight Adjustment Lever for Loaded
Conditions
1. Headlight adjuster lever (unloaded
position)
2. Headlight adjuster lever (loaded
position)
For normal (unloaded) conditions the
headlight adjuster lever should be set in the
horizontal position (1).
For loaded conditions rotate the headlight
adjuster downwards until it stops (2). This will
lower the headlight beams by
approximately 2°.
3
2
1
chfb
To Next Page
Loading...
