25
General Information
Each display provides the following
information:
Odometer
Shows the total distance that the motorcycle
has travelled.
Cruise Control
If the cruise control is activated, this display
will show the road speed set for cruise
control. If the speed control is not activated,
two dashes will be visible in the display area.
Average Speed
The average speed is calculated from when
the trip computer was last reset. After being
reset the display will show dashes until
1 mile/km has been covered.
Instantaneous Fuel Consumption
An indication of the fuel consumption at an
instant in time.
Average Fuel Consumption
An indication of the average fuel
consumption. After being reset the display
will show dashes until 0.1 miles/km has been
covered.
Trip Time
The total time elapsed since the trip meter
was last set to zero.
Range to Empty
This is an indication of the probable distance
that can be travelled on the remaining fuel in
the tank.
Trip Distance
The total trip distance travelled since the trip
meter was last set to zero.
Trip Meter Reset
To reset either of the trip meters, select and
display the trip meter to be zeroed then press
the set button for 2 seconds. After 2 seconds,
the trip meter on display will reset to zero.
Note:
• When a trip meter is reset to zero,
the trip time, average fuel
consumption and average speed
will also be set to zero for that trip
meter.
To exit the trip meter, press and release home
button and the odometer in the trip 1 menu
will be visible in the display screen.
1. Home button
To Next Page
Loading...
