43
General Information
Traction Control Warning Light - If
Traction Control is Fitted
Depending on what setting has
been selected for the traction
control system (see page 32), the
warning light will illuminate as
follows:
• '01' - the light is OFF but it will flash
on and off when the traction control
is working to limit rear wheel spin;
• '02' - the light will flash on and off
slowly but will flash on and off at a
faster rate when the traction control
is working to limit rear wheel spin;
• 'oFF' - the light is constantly on.
If the traction control light and the
malfunction indicator light (MIL) become
illuminated at the same time, there is a
malfunction with the traction control which
requires investigation by your local Triumph
dealer.
Cruise Control Light
The cruise control can only be
activated when the motorcycle is
travelling at a speed between
30 to 100 mph (48 to 160 km/h) and is in
4th gear or higher. When activated, the cruise
control light in the instrument's will be
illuminated (see page 52).
1. Cruise control light
If the traction control is not functioning,
care must be taken when accelerating and
cornering on wet/slippery road surfaces to
avoid rear wheel spin. Do not continue to
ride for longer than is necessary with the
MIL and traction control lights illuminated.
Contact an authorized Triumph dealer as
soon as possible to have the fault checked.
Hard acceleration and cornering in this
situation may cause the rear wheel to spin
resulting in loss of motorcycle control and
an accident.
Cruise control must only be used where
you can ride safely at a steady speed.
Cruise control should not be used when
riding in heavy traffic, on roads with sharp/
blind bends or when they are slippery.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when they
are slippery, may result in loss of
motorcycle control and an accident.
MIN
-1
x 1000
TC
1
To Next Page
Loading...
