Triumph Tiger Explorer - Ignition Switch;Steering Lock; Engine Immobilizer; Ignition Switch Positions

45
General Information
Ignition Switch/Steering Lock
1. Ignition switch/steering lock
2. LOCK position
3. OFF position
4. ON position
5. PARK position
Engine immobilizer
The ignition barrel housing acts as the
antenna for the engine immobilizer.
When the ignition switch is turned to the OFF
position and the ignition key is removed, the
engine immobilizer is on (see page 40). The
engine immobilizer is turned off when the
ignition key is in the ignition switch and it is
turned to the ON position.
Ignition Switch Positions
This is a four position, key operated switch.
The key can be removed from the switch
only when it is in the OFF, LOCK or P (PARK)
position.
TO LOCK: Turn the handlebar fully to the
left, turn the key to the OFF position, push
and fully release the key, then rotate it to the
LOCK position.
PARKING: Turn the key from the LOCK
position to the P position. The steering will
remain locked, and the position lights will be
switched on.
Note:
• Do not leave the steering lock in
the P position for long periods of
time as this will cause the battery
to discharge.
P
U
S
H
P
O
F
F
O
N
3
2
5
1
4
Warning
For reasons of security and safety, always
move the ignition switch to the OFF
position and remove the key when leaving
the motorcycle unattended.
Any unauthorized use of the motorcycle
may cause injury to the rider, other road
users and pedestrians and may also cause
damage to the motorcycle.