5 Machine overview ........................................................................................................................... 36
5.1 General overview ...................................................................................................................... 36
5.1.1 Operation panel .............................................................................................................. 37
5.1.2 Front door ....................................................................................................................... 41
5.2 Tables (multifunctional table concept) ...................................................................................... 42
5.2.1 Multifunctional base frame ............................................................................................. 42
5.2.2 Ferromagnetic engraving table (standard) ..................................................................... 42
5.2.3 Vacuum table.................................................................................................................. 42
5.2.4 Cutting tables.................................................................................................................. 43
5.2.5 Additional tabletops ........................................................................................................ 44
5.3 Lenses and nozzles .................................................................................................................. 45
6 Transport, packaging and storage ............................................................................................... 46
6.1 Safety notes .............................................................................................................................. 46
6.2 Transport and unloading ........................................................................................................... 46
6.2.1 Required tools ................................................................................................................ 46
6.2.2 Transport conditions ....................................................................................................... 47
6.3 Storage and storage conditions ................................................................................................ 48
6.4 Unpacking the machine ............................................................................................................ 49
6.5 Transport inspection and reporting of defects .......................................................................... 51
6.6 Relocation of the machine ........................................................................................................ 51
7 Setup and installation .................................................................................................................... 52
7.1 Safety notes .............................................................................................................................. 52
7.2 Operating environment ............................................................................................................. 53
7.2.1 Space requirements ....................................................................................................... 54
7.3 Setup......................................................................................................................................... 54
7.4 Connections .............................................................................................................................. 55
7.4.1 Connecting the mains ..................................................................................................... 56
7.4.2 Connecting the PC ......................................................................................................... 56
7.4.3 Connecting a Trotec exhaust system ............................................................................. 57
8 Operation ......................................................................................................................................... 58
8.1 Before operation ....................................................................................................................... 58
8.2 Software .................................................................................................................................... 58
8.3 Power ON/OFF ......................................................................................................................... 59
8.3.1 Power ON ....................................................................................................................... 59
8.3.2 Power OFF ..................................................................................................................... 59
8.4 Table placement ....................................................................................................................... 60
8.5 Lens placement ........................................................................................................................ 61
8.5.1 Lens position .................................................................................................................. 61
8.6 Switch laser source manually ................................................................................................... 62
8.7 Focusing methods .................................................................................................................... 63
8.7.1 Focus tool ....................................................................................................................... 64
8.7.2 Software focus ................................................................................................................ 65
8.7.3 Light bar focus ................................................................................................................ 67
8.7.4 Sonar Technology™ ....................................................................................................... 67
8.8 Rotary engraving attachment (option) ...................................................................................... 68
8.8.1 Installation and commissioning ...................................................................................... 69
8.8.2 Mounting the work piece ................................................................................................ 70
To Next Page
Loading...
Need help?
General
