✓
After the count time, the gauge displays the measurement
results.
where: %MA = percent Marshall
WD = wet density
%VOIDS = 100
×
1 – WD
VOIDLESS
(displayed only when enabled)
If a project is enabled (see the Handling Project Data section on
page 5–5),
press the 〈STORE〉 key to store the measurement(s).
To scroll through the results, use the arrow keys. Return to the
Ready screen by pressing the
〈ESC〉 key, or press the 〈START〉
key to make another measurement.
✓
Lift the gauge from the test site using the source rod handle.
This returns the source rod to the SAFE position. When not
taking readings, always keep the source rod in the SAFE
position.
WD = xxxxx pcf
%VOIDS = xxxxx
To Next Page
Loading...
