SETUP
After turning the gauge on for the first time, set up the software. The
gauge stores the software setup, so the operator does not need to
enter a new setup each time the gauge is turned on. Although the
values noted below may be changed at any time.
The Model 3450 offers a Current Status feature that enables the
operator to view the current gauge status, setup, and constants; and
to print the current gauge status and calibration constants. The
gauge status includes the customer name, software version, units,
count time, measurement mode, Marshall value, Proctor value,
Voidless density value, measurement mode status, percent air voids
status, specific gravity, offset status, offset values, printer setup, and
special calibration. The gauge setup includes the software version,
gauge serial number, source rod type, last reset date, charger and
battery status, display time out, backlight setup, beeper setup, and
depth indicator setup. The constants include calibration constants
and status.
NOTE
The Special key contains several functions. These
functions are typically not used on a day-to-day basis.
The features that are accessed through the Special key
are denoted in this chapter with the phrase (SPECIAL
KEY) in the section title.
CURRENT STATUS (SPECIAL KEY)
Access the Special functions menu by pressing the 〈SPECIAL〉 key.
At the Special functions menu, press
〈2〉 Gauge Status/Test to
access the Gauge Status/Test menu. At the Gauge Status/Test menu,
press
〈1〉 Current Status. From this menu, press 〈1〉 View Status.
2-
View Setup
3-
View Constants
4-
Print Status
To Next Page
Loading...
