7-1
CHAPTER 7
Specifications
Note that specifications are subject to change without notice.
P h y s i c a l
Interface Module: 20.5 cm x 10.6 cm x 7.3 cm
High Flow Module: 15 cm x 6.7 cm x 6.1 cm
Low Flow Module: 12.7 cm x 5.1 cm x 2.8 cm
High Flow Module:
• Inlet: 22 mm female ISO taper.
• Outlet: 22 mm male ISO taper.
Low Flow Module:
• Inlet: 3/8 inch tube
• Outlet: 3/8 inch tube
Interface module is 0.85 kg
Total 1.1 kg for interface and high flow module plus cable
E n v i r o n m e n t a l
Operating: 5 to 40 °C, Humidity: -20 to 35 °C Dew Point, non--condensing
Storage: -40 to 70 °C, Humidity: -40 to 35 °C Dew Point, non-condensing
Operating: 57.1 to 106 kPa
Storage: 15000 meters
Indoor Use, Operating Altitude up to 4000 m
Pollution degree I or II
8 hours under typical usage (with 1 flow module connected)
Lithium-Ion, proprietary form factor, 7.2 V 6.4 AHr
C o m p l i a n c e
The Certifier Plus Test System includes the following marks, compliance, and FCC statements:
• CE mark, UKCA mark, ETL Listed mark, RCM mark, and RoHS compliance.
• Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
• Per FCC 15.21, The user manual or instruction manual for an intentional or unintentional radiator
shall caution the user that changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
To Next Page
Loading...
