Page 103 of 110 Pages
Attention:
Use protective gloves in order not to burn your hands with the hot
steam.
5. Press the STOP key to interrupt the operation, and exhaust
steam from the chamber.
6. Wait until the pressure decreases to zero, only then the door
can be opened.
15.6 Cleaning the water sensor
It is required that the water sensor be cleaned at least once per week.
Cleaning the sensor will ensure that the water level in the chamber is
properly reported to the microprocessor all during the cycle.
The water sensor is located in the rear of the chamber. It is easily cleaned
using a damp cloth or sponge, you may use a mild soapy solution if you
like. It is important to wipe the sides of the sensor as well as the tip, to
remove any dirt or debris that may have built up.
To Next Page
Loading...
