Page 79 of 110 Pages
4. 0000 is displayed on the screen with the cursor blinking on the right
digit.
5. To increase or decrease the digits, press the UP or DOWN keys.
6. After changing the code to 0001 move the cursor to Set by pressing
the START/STOP key.
7. When Set is blinking, press the UP or DOWN keys to enter the
MAIN MENU of the autoclave.
The following screen will be displayed:
In order to exit the Main Menu screen move the cursor to Exit by
pressing START/STOP Key. When Exit is blinking press UP or
DOWN keys.
8. To browse through the directories, use the UP or DOWN keys.
9. When the required directory is blinking, press the START/STOP
key. The required screen will be displayed.
10. In order to exit this screen follows one of the next:
Move the cursor to Exit with the UP or DOWN keys and
select it by pressing the START/STOP key.
Press the UP and DOWN keys simultaneously.
13.3 Directories and subdirectories
The operator (Admin) may perform the following:
To Next Page
Loading...
