Page 58 of 110 Pages
11.4 Tubing
When placing tubing on the tray, make sure that both ends are open, without
sharp bends or twists.
11.5 Liquids
Use only heat-proof glass, filled 2/3 full.
Ensure that the glass container is covered but not sealed to prevent pressure
build-up.
Note:
For isothermal cycles, insert one PT100 temperature sensor into the
liquid, and allow the other PT100 temperature sensor to hang loose inside
the chamber, (see the figure below).
For proper sterilization, ensure all the bottles are filled with
approximately the same amount of liquid.
To Next Page
Loading...
