Tuttnauer 3840 - Cycle Parameters (Custom Program = Duplicate Cycle)

Page 80 of 110 Pages
Drying
1
Ending
Global
System Parameters
Print Rate All
Print Rate Sterilization
Screen Saver
Maintenance
Export gain offset to USB
Reset atmospheric pressure
Printer test
Print all gain and offset
13.4 Cycle Parameters (Custom program = duplicate cycle)
This directory applicable only for custom 1 and custom 2 programs
Subdirectory
Property
Purge
Purge Time
Purge Temperature
Create Pulse
Pulse A Count
Pulse A Stay Time
Pulse A Low Pressure
Pulse A High Pressure
Pulse B Count
Pulse B Stay Time
Pulse B Low Pressure
Pulse B High Pressure
Heating
Sterilization Temperature
Sterilization
Sterilization Temperature
Sterilization Time
Cooling
Cool Mode
Cool End Temperature
Cool Exhaust Rate
Exhaust
Exhaust Mode
Drying
Dry Time
Dry Air On Pressure
Dry Air Off Pressure
Ending
End Temperature
Exhaust Mode
Global
Bio Hazard
Multiple Cycles
Multiple Cycles Gap
Jacket Temperature
Jacket Mode
1
For all the standard sterilization cycles and for Bowie and Dick test, the only changeable cycle
parameter is drying (dry time). For the custom cycles created by duplication (see section 7.13 change the
Keep Heat Time), and for the Warm Up cycle, all the options listed in this table are changeable.