Page 61 of 110 Pages
If the door has opened successfully, the following screen will appear
12.3 Safety
Protective equipment and clothes and other safety instructions should be
implemented in accordance with local and national regulations and/or
rules!
For proper sterilization - Do not overload the chamber. Only
autoclavable products shall be used; please refer to the manufacturer
instructions for sterilization of unknown materials or instruments.
12.4 Loading
Load the autoclave properly according to instructions in sec. 9
PREPARATION BEFORE STERILIZATION.
Please Mind:
Compatible material
Proper weight
12.5 Operation
1. Select the program.
UP key: next program.
DOWN key: previous program.
Attention:
Selecting a program is possible only when the door is open.
2. Verify that you chose the required cycle.
3. If the autoclave is equipped with a printer verify that a paper roll
is inserted in the printer. If not - insert as per para. 5.2.
12.6 Closing the door
In order to close the door, follow the next steps:
When the door is open, the screen below will be displayed:
To Next Page
Loading...
