Page 63 of 110 Pages
12.7 Starting cycle
Start the cycle by pressing the START/STOP key.
If your autoclave supports CFR 21 part 11 standard,
perform the following procedure:
SELECT USER screen will be displayed:
1. Enter the Enter Code screen by moving the cursor to your
username (Use Up and Down keys) and pressing
START/STOP key. The following screen will be displayed:
2. 0000 is displayed on the screen with the cursor blinking
on the right digit.
3. To increase or decrease the digits, press the UP or
DOWN keys.
4. Set your password, then move the cursor to Set
by pressing the START/STOP key.
To Next Page
Loading...
