Page 88 of 110 Pages
13.5.1 Print Rate All
This subdirectory allows changing the printing rate during the
whole cycle except sterilization stage.
1. To increase or decrease the digits, press the UP or DOWN
keys.
2. After changing the value move the cursor to Set by pressing
the START/STOP key.
3. When Set is blinking, press the UP or DOWN keys in order
to confirm changes and return to the previous screen.
4. In order to exit this screen follows one of the next:
In order to exit this screen move the cursor to Exit with
the START/STOP key and select it by pressing the UP
or DOWN keys.
Press the UP and DOWN keys simultaneously.
13.5.2 Print Rate Sterilization
This subdirectory allows to change the printing rate during
sterilization stage.
To Next Page
Loading...
