Lap timer indicates the time taken to complete a
particular lap. On entering the lap timer mode, press
the ‘Info switch ( )’ on the handle bar to start a lap
timer. The timer starts counting current lap’s time and
displays in active lap timer as shown (before starting
the lap timer, ensure that the timer is reset. Refer
page No. 27 for details).
11c. Lap timer
KNOW YOUR TVS APACHE RTR 200 4V
20
Lap timer works only when the lap timer mode is
active. Once the lap timer is stopped by pressing the
‘Info switch’, the timer cannot be started again until
the timer is reset. Only last three lap’s timing will
be displayed in the cluster on entering the lap
timer mode.
Note
Press the ‘Info switch’ again to stop the current lap
timer and to start a new lap. Existing lap timings will
be displayed as shown below and continue to get
updated whenever a new lap is started and stopped.
Long press the ‘Info switch’ for few seconds (more
than 1 second and less than 3 seconds) to stop the lap
timer count.
To start a lap timer again, after stopping it by pressing
the ‘Info switch’, the lap timer need to be reset as
explained page No. 27. You can record any number of
laps but last three lap’s details only will be displayed in
the cluster.
11d. Average speed indicator
This is the default mode if the instrument cluster is not
connected with your mobile device via ‘Bluetooth’.
Using ‘SET’ button this mode can be turned ‘ON’ if the
cluster is connected to you mobile. In this mode the
cluster calculates and displays the average running
speed of the vehicle.
To Next Page
Loading...
Need help?
General
