Ensure the transmission is in neutral or else press the
clutch lever before engaging the electric starter
switch ‘ ‘.
1. Electric starter switch
HANDLE BAR RIGHT SIDE
5. Head lamp high / low beam switch
The head lamp glows automatically once the engine is
started. Only the head lamp beam (high/low) can be
controlled with the beam control switch.
Press the top end of switch for ‘High’ beam ’ ‘ and
bottom end for ‘ Low’ beam ‘ ‘.
KNOW YOUR TVS APACHE RTR 200 4V
Note
Note
Ensure to turn ON the engine cut-off switch before
starting the vehicle.
Release the electric starter switch immediately after
pressing.
Once the engine is started the head lamp glows
automatically. Only head lamp beam (high/low) can
be controlled using beam control switch.
It is strongly recommended to ride thevehicle in ‘low’
beam during day.
Use appropriate head lamp beam 'high / low' as per
the traffic and road conditions for your safety and
avoid inconvenience to other riders.
Warning
1
4
3
2
44
To Next Page
Loading...
