KNOW YOUR TVS APACHE RTR 200 4V
l To reset any of the trip meter while ensuring
the display is in ‘TRIP 1’ or ‘TRIP 2’, press and
hold the set button for a few seconds.
l To reset the timings, keep the display in ‘LAP
TIMER MODE’ and wait till the cluster
displays the lap timings. Now press and hold
the Set button for a few seconds.
If ignition is turned OFF when the meter is in ODO or
TRIP meters, then the respective meters will be
displayed in the next ignition ‘ON’. If any other modes
other than these were set during ignition ‘OFF’, then
‘ ODO ‘ meter will be displayed in the next ignition
‘ON’.
1. In ‘ODO’ mode, Press the Mode button once and
twice to enter ‘ TRIP 1 ‘ or ‘ TRIP 2 ‘ meters
respectively.
Setting the digital display
Every press of the mode button changes the display
to other mode. Follow the below procedures to
change the display to desired mode.
2. In ‘TRIP 2’ meter mode, Press the ‘Mode’ button
once to enter lap timer mode. On entering the lap
timer mode, a message ‘ ’
and last three laps timing will be displayed in the
cluster’s display.
4. In ‘TRIP 2’ meter mode, press the Mode button
thrice to enter shortest time mode. On entering
this mode, last achieved shortest time ‘ ‘
and overall best time ‘ ‘ will
be displayed in the cluster’s display.
3. In ‘TRIP 2’ meter mode, press the ‘Mode’ button
twice to enter high speed mode. On entering
this mode a message ‘ ‘
and last achieved high speed data will be
displayed in the cluster’s display.
l To reset the high speed recorded, keep the
display in ‘HIGH SPEED’ mode and press the
‘Set’ button for a few seconds.
l To reset the last achieved shortest time, keep
the display in ‘SHORTEST TIME MODE’,
press and hold the Set button for few a
seconds. Please remember only last / current
record will be reset and best time display will
remain same until new best time is achieved.
5. Press the ‘Mode’ button once to change the
display to ‘ODO’ mode again.
27
To Next Page
Loading...
Need help?
General
