F3200 Operator's Manual Document No: LT0119
Operating Instructions - Relay/Output Functions
Page 8-10 29 July 2002 Issue 2.04
8.8 ANCILLARY RELAY RESET SUPERVISION FAULT
8.8.1 FUNCTION
To reset a latched supervision fault on a local ancillary relay.
For network systems, to reset a latched supervision fault on an ancillary relay on a
remote panel, use a zone reset command. Refer Section 11.10.
8.8.2 OPERATING SEQUENCE
To reset a latched supervision fault on a local ancillary relay, from the base display
press:
to select ancillary relays
then press numeric key "1", "2" or "3" followed by the ENTER key to select the desired
ancillary relay. Then press:
to reset the fault.
If the fault is still physically present on the relay wiring then the relay status will remain in
fault.
To Next Page
Loading...
