F3200 Operator's Manual Document No: LT0119
Operating Instructions - Relay/Output Functions
Page 8-4 29 July 2002 Issue 2.04
8.2 MODULE RELAY STATUS RECALL
8.2.1 FUNCTION
To display the status of a local module relay.
For network systems, to display the status of a relay on a remote panel you need to use
the zone number associated with the relay and do a zone recall command. Refer to
Section 11.10.
8.2.2 OPERATING SEQUENCE
To display the status of a local module relay, from the base display press:
to select module relays
then press:
to display the status of relay nn.
The status display will show the relay number, zone number and name on the top line
and information on the bottom line as follows:
deactivated - if the relay is de-energised
activated - if the relay is energized
normal - no supervision fault
fault - supervision fault
open circuit - supervision fault
short circuit - supervision fault
isolated
deisolated
The "RESET", "ISOLATE" and "TEST" keys may be used from this display and "NEXT"
and "PREV" may be used to step through the module relays.
To Next Page
Loading...
