Tyco F3200 - Network System Commands

F3200 Operator's Manual Document No: LT0119
Network Systems
Page 11-14 29 July 2002 Issue 2.04
11.8 NETWORK SYSTEM COMMANDS
11.8.1 NETWORK SYSTEM TEST
To initiate a system test on a remote device from the base display, press:
Then enter the SID number 1 to 254 using the numeric keys 0 to 9, followed by the
ENTER key. The top line of the display then shows the name of the selected SID and
the bottom line gives a list of options 1 to 4 as follows:
1:System, 2:Zone, 3:Bells, 4:Battery
Select option 1, i.e. press numeric key 1 to initiate the test.
The display will indicate if the command was accepted by the remote device. The
remote device may send an exception message to indicate if the test passed or failed.
11.8.2 NETWORK SYSTEM BATTERY TEST
To initiate a battery test on a remote device from the base display, press:
Then enter the SID number 1 to 254 using the numeric keys 0 to 9, followed by the
ENTER key.
The top line of the display then shows the name of the selected SID and the bottom line
gives a list of options 1 to 4 as follows:
1:System, 2:Zone, 3:Bells, 4:Battery
Select Option 4 to initiate a battery test at the remote device.
The display will indicate if the command was accepted by the remote device. The
remote device may send an exception message to indicate if the test passed or failed.