Document No: LT0119 F3200 Operator's Manual
Network Systems
Issue 2.04 29 July 2002 Page 11-13
NETWORK COMMAND RESPONSES (CONTINUED)
9. "Network Panel Not Processing"
The remote panel is in program mode and cannot accept commands.
10. "Retrieve Timeout. No Response"
The Remote Panel did not acknowledge a request for information.
11. "Unable to Access Network"
This indicates a hardware fault such as a break or short circuit on the network
cabling.
12. "Local Net Transmit Queue Full"
All commands initiated are entered into a queue until the network driver is able
to send them. It is only in extreme or fault situations that the queue would
become full.
In a fault situation it may be that the queue remains full until the fault clears.
The command should be retried.
11.7.2 EXCEPTION MESSAGES
When an exception message is received from a remote device, it is immediately shown
on the display, temporarily interrupting whatever is being shown on the display at the
time. The display shows the number of the SID which sent the exception message. The
pressing of any key will clear the exception message and restore the display.
Exception messages which may be shown are:
"Not All Zones De-Isolated"
The zone range de-isolation command processed did not de-isolate one or
more zones because they were in alarm or fault.
"Zxxxxx Test Passed"
"Zxxxxx Test Failed"
"Zxxxxx Test Aborted"
"Zxxxxx Test Time Out"
The previous Zone test command issued to zone xxxxx had the indicated
result.
"System Test Passed"
"System Test Failed"
"System Test Aborted"
The previous System test command had the indicated result.
"Battery Test Passed"
"Battery Test Failed"
"Battery Test Aborted"
The previous Battery test command had the indicated result.
To Next Page
Loading...
