F3200 Operator's Manual Document No: LT0119
Network Systems
Page 11-10 29 July 2002 Issue 2.04
11.6 SYSTEM FAULT RECALL/NET PANEL
STATUS RECALL
As described in Section 6.6.2, a RECALL SYSTEM command can be used to recall all
system faults.
As well as the faults listed in Section 6.6.3, a system fault recall (or network device
status recall) will display up to 5 "pages" of information for each device on the network,
beginning with the local panel. The "pages" are numbered 0 to 4, and the information
shown is described in Section 11.6.3.
11.6.1 NETWORK SYSTEM FAULT RECALL
This is the same as described in Section 6.6.2. From the base display, press:
Use NEXT and PREV keys to step through the faults. The system faults shown are
listed in Section 6.6.3 plus the additional faults listed in Section 11.6.3 below.
11.6.2 NETWORK PANEL STATUS RECALL
The five pages of panel status listed in Section 11.6.3 may be recalled by a panel status
recall command. From the base display, press:
Then press either 1, 2 or 3 to select the desired option as follows:
1. All net SIDs.
2. Select SID.
3. All off normal SIDs.
Option 1: All net SIDs, will step through all panels on the network that are in the SID list
of this panel, starting with the local panel.
It will display pages 0-3 only if there are any off normal conditions on those pages for
that panel, but will always display page 4 (totals) even if the totals are zero.
Option 2: Select SID, will prompt for the entry of a SID number and will start the recall
from the selected SID, and is otherwise the same as Option 1.
Option 3: All off normal SIDs, will display only those SIDs that have off normal conditions
on pages 0-3 or have non-zero totals on Page 4.
To Next Page
Loading...
