Document No: LT0119 F3200 Operator's Manual
Operating Instructions - Zone Functions
Issue 2.04 29 July 2002 Page 7-5
7.2 ZONE ISOLATE OR DE-ISOLATE
7.2.1 FUNCTION
To isolate or de-isolate a selected zone or group of zones.
For network systems: to isolate/de-isolate a local zone follow this section; to isolate/de-
isolate a remote zone refer to Section 11.10.4.
7.2.2 OPERATING SEQUENCE - SINGLE ZONE
From the base display, press:
To isolate or de-isolate zone n n.
To isolate the zone shown on a zone status recall display, press:
followed by
The LCD displays the current isolate status of the zone. Pressing the "ACK" key
changes the isolate state. Pressing the "CLEAR ESC" key aborts the Isolate command.
To Next Page
Loading...
