Document No: LT0119 F3200 Operator's Manual
Operating Instructions - Relay/Output Functions
Issue 2.04 29 July 2002 Page 8-11
8.9 ANCILLARY RELAY TEST
8.9.1 FUNCTION
To briefly turn on a local ancillary relay output for five seconds.
If the relay is isolated the test command will not energise the relay.
If the relay is already energised before the test starts then the test command will have no
effect on the relay and will not de-energise it.
For network systems, to test an ancillary relay on a remote panel, use a zone operate
test command. Refer to Section 11.10.
8.9.2 OPERATING SEQUENCE
To test a local ancillary relay, from the base display press:
to select ancillary relays
then press
then press "ACK" to energise the relay output, or press "CLEAR ESC" to abort. The
relay will be energised for five seconds or until "ACK" is pressed.
8.9.3 NOTES
Depending on programming, a test command may not be allowed on particular relays. In
which case, the message “This relay may not be tested” will appear when an attempt is
made to test it.
To Next Page
Loading...
