Tyco F3200 - Set System Time; Set System Date

F3200 Operator's Manual Document No: LT0119
Operating Instructions - System Functions
Page 6-14 29 July 2002 Issue 2.04
6.9 SET SYSTEM TIME
6.9.1 FUNCTION
Allows an operator to set the time in the real-time clock within the FIP. For network
systems, the new time may also be sent on the network to set the time at other devices
(depending on programming).
6.9.2 OPERATING SEQUENCE
To set the time, press:
The current time is displayed. Enter the new time, in 24 hour format, i.e. the hours value
is 00 to 23 where 01 is 1am and 23 is 11pm. Hours, minutes and seconds may be
entered. E.g. to set the time to 13:52:40pm, press: "135240 ENTER".
6.10 SET SYSTEM DATE
6.10.1 FUNCTION
Allows an operator to set the date in the real-time clock within the FIP. For network
systems, the new date may also be sent on the network to set the date at other devices
(depending on programming).
6.10.2 OPERATING SEQUENCE
To set the date, press:
The current date is displayed. Enter the new date.
E.g. To set the date to 14/07/94, press: "140794 ENTER"