Tyco F3200 - Page 69

Document No: LT0119 F3200 Operator's Manual
Operating Instructions - System Functions
Issue 2.04 29 July 2002 Page 6-11
SYSTEM FAULT RECALL FAULT LIST (CONTINUED)
26. Battery is low
This message indicates the battery voltage is low. When PSU faults are inhibited
for 24 hours, this message will still appear in a system fault recall if the voltage is
low even though it is not creating a system fault.
27. Battery connection fail
This message indicates the battery is not connected, but may occur with the
battery connected if the battery is faulty or has a low charge. When PSU faults
are inhibited for 24 hours, this message will still appear in a system fault recall if
the battery appears to be not connected even though it is not creating a system
fault.
28. Battery capacity low
This message indicates an automatic battery test failed, i.e. the battery has a low
charge.
29. External defect
This fault occurs only on an NDU in New Zealand mode and indicates the
External Defect input on the N.Z. Display Extender board is active.
30. External evac defect
This message indicates the External Evac defect input on the N.Z. Display
Extender board is active.
31. Silence alarms
This message indicates the Silence Alarms input on the N.Z. Display Extender
board is active.
32. Trial evac
This message indicates the Trial Evac input on the N.Z. Display Extender board
is active.
33. Services restore
This message indicates the Services Restore input on the N.Z. Display Extender
board is active.
34. Brigade iso/test
This message indicates the Brigade Iso/Test input (dual purpose) on the N.Z.
Display Extender board is active.