Tyco Galaxy SC Controller - Page 151

Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Configuration 4 - 59
PH1-2, PH2-3, PH3-1 Voltage: Voltage RPM channels, (transducers
required) can be linked to monitor the phase to phase ac voltages.
PH1, PH2, PH3 Fail: Binary RPM channels, can be linked to monitor
the status of an external ac fail alarm device monitoring individual
phases.
Master AC Sw Fail Alarm: Binary RPM channel, can be linked to
monitor the status of an external ac fail alarm device.
DC Distribution
Links
Configure → Distribution → DC. This dialog allows the linking of a
shunt, derived or binary RPM channel to report individual loads, total
switching or transmission loads, or a Fuse State object in the system.
Maintenance
Reminders
Configure → Maintenance Reminders. As many as twelve
60-character messages can be configured, each with an associated date
and time for activation. Call out to any or all of the four configured
call-out phone numbers can be selected. (Customer configured option.)
Notepads Configure → Notepads → User / Super User. Notepad for general
purpose text (15 lines of 60 characters). Notepads can be enabled so that
a user logging on will be notified. The User notepad is read/write for all
users. Super User notepad is read/write for the super user and
administrator but read only for a user. (Customer configured option.)
Controller Option
Inventory
Configure → Inventory → Controller Options. (Customer
configured option.)
Controller
Distribution
Inventory
Configure → Inventory → Distribution. (Customer configured
option.)
Peripheral Monitor
Inventory
Configure → Inventory → Peripheral Monitor. (Customer
configured option.)
Plant Inventory Configure → Inventory → Plant. (Customer configured option.)
Rectifier Inventory Configure → Inventory → Rectifier. (Customer configured option.)