Tyco Electronics Galaxy SC Controller J85501F-1
4 - 62 Configuration Issue 13 February 2001
their rated value should the other rectifiers in the plant be adjusted to an
output voltage that is below that set for the serial rectifiers in the Float
Set Point field.
Boost Current Limit: Sets the rectifier’s current limit value as a
percentage of rectifier capacity while the system is in the Boost mode.
Statistics Configure → Statistics → Busy Hour → BH1 to BH4 / DCBH1.
(Customer configured option.)
Trend Studies Configure → Statistics → Trend → TR1 to TR8 / DCTH1.
(Customer configured option.)
System Hardware
and Software
Configure → System → Hardware & Software Config. Several
controller features must be enabled both by Hardware switches located
on circuit packs as well as in software. Both switches must be enabled
for the feature to operate.
Local Port: Enables or Disables the software switches for the Read/
Write permissions for the local port. The Hardware switch associated
with this feature is SW203-6 on the BJH pack.
Modem Port: Enables or Disables the software switches for the Read/
Write permissions for the modem port. The Hardware switch associated
with this feature is SW203-4 on the BJH pack.
Aux Port: Enables or Disables the Read/Write permissions for the port.
The Hardware switch associated with this feature is SW203-5 on the
BJH pack.
Local Port Mode: Select from Terminal, Event Log (printer), TL1.
Critical = Maj: If the software switches for is enabled all Critical
alarms in the system will behave as though they were Major severity.
The Hardware switch associated with this feature is SW202-6 on the
BJB pack.
Config via Front Panel: Sets the software switches for permission to
change configurations from the front panel. The Hardware switch
associated with this feature is SW202-8 on the BJB pack.
Serial Port Config: Enables or Disables the software switches for
changes to the communication parameters of the local, remote and
To Next Page
Loading...
Need help?
General
