Tyco Electronics Galaxy SC Controller J85501F-1
Issue 13 February 2001 Operation 6 - 1
6 Operation
Introduction This section tells you in detail how to operate the Galaxy SC Controller.
Topics include operation of both the Basic and Intelligent controllers
from Galaxy SC’s front panel, operating Galaxy SC from a personal
computer with the Windows-based EasyView software, and using the
T1.317 interface from a remote terminal.
Additional information regarding many of the features shown here can
be found in Chapter 7, Feature Descriptions.
Basic
Controller’s
Front Panel
Operation
The sections that follow depict front panel displays that differ
slightly from version to version of the Galaxy software. The paths
shown here are as of Version 6.5.
Alarm Cut Off To perform the ACO (Alarm Cut Off) operation, first ensure that the
ACO CR, ACO MJ, ACO MN in the ALARM menu is enabled. The
ACO CR applies to alarms of CRITICAL severity only, the ACO MJ is
for the MAJOR alarm only, and ACO MN is for the MINOR alarm only.
You can selectively perform the ACO operation on each individual class
of alarm. Press the <MENU> key to bring up the MAIN menu. Use the
<UP>, <DOWN>, <LEFT>, <RIGHT> arrow keys to move the cursor
to the CONFIG field. Press <ENTER> key to bring the CONFIG
(configuration) menu up, move the cursor to ALARM field, press
<ENTER> key to bring the ALARM menu up. If any of the ACO CR,
ACO MJ, ACO MN fields need to be changed, move the cursor to that
field, use the <+>, <-> key to change the field value and press
<ENTER> each time to save each change.
Next, bring up the MAIN menu (press <MENU > key), move the cursor
to the ACO field and press <ENTER> to perform the Alarm Cut Off.
This will disengage the corresponding severity contact relay on the front
panel. Please note that the ACO operation only affects the current active
To Next Page
Loading...
Need help?
General
