Tyco Galaxy SC Controller User Manual

Tyco Electronics Galaxy SC Controller J85501F-1
6 - 34 Operation Issue 13 February 2001
MET G01
MET G01,LOAD
Reserve Time
Prediction
This section describes how to configure and view the parameters that are
related to the reserve time prediction algorithm. The reserve time
parameters are all attributes of the DC Plant object identified as DC1.
The examples below illustrate how to change and view these
parameters:
STA DC1, RTM report the reserve time
CHA DC1,NST=4 change the number of battery strings to 4
CHA DC1,CPS=24 change the number battery cells
per string to 24
CHA DC1,BTY=“IR-125”change the battery type to IR-125
STA DC1,TPP report if temperature probe is present
(0:no 1:yes)
STA DC1,UBT report the universal battery temperature, if
present
STA DC1,TRD report the total rectifier drain
STA DC1,VDC report the plant DC voltage
STA DC1,ADC report the plant DC current
The Reserve Time Too Low alarm is identified as RTL1 and is linked to
the DC plant object. The example below illustrates how the alarm’s
threshold can be set and how to check if the alarm is active:
CHA RTL1,THR=3 change the reserve time too low
threshold to 3 hours
ALA DC1 report active DC plant alarms
To view the battery on discharge history, which includes the reserve
time at the beginning of discharge, use the following command:
HIS DC1,BOD report the battery on discharge history
Security Level and
Password
Management
To change security levels from the T1.317 interface use the LOGIN
command with either the user, super-user, or administrator passwords.
Normally, only one login as the super-user or administrator level is
allowed at a time. If an attempt is made to login as a super-user while
someone else is logged in as a super-user or administrator this error
message will be reported:
-226, ONE SUPER-USER/ADMINISTRATOR ALLOWED

Tyco Galaxy SC Controller Specifications

General

Brand	Tyco
Model	Galaxy SC Controller
Category	Controller
Language	English